На рутракере есть торрент Mitchell transmissions 1-2007
То есть митчел специально по трансмиссиям.
Дык вот, весит он 11 гигабайт-2 образа ДВД.
Не поленитесь, скачайте. Там есть ОБУЧЕНИЕ правильной переборке трансмиссий и проверке\устранению проблем гидроблок(ов) в т.ч. по конкретным проблемам конкретных АТ.
Цветные, с картинками
И как ream-ить правильно, и вакуум тест, и влажный воздух (valve body servicing manual -КОНКРЕТНО ПО ГИДРОБЛОКАМ).
Инфа на основе Соннакса и опыта американских агрегатчиков.
Кроме того, более-менее охвачен ремонт АТ, что поступали на америк рынок.
Правда, всё на английском.
Общие советы по ремонту АКП :
• Check and set endplay on ALL units using
selective shims, washers and bearings
• Valve Bodies
•Take all the valves out of the valve body
• Check valves and bores for wear
• Flat file valve body mating surfaces
• Pumps
• Check all clearances
• Check for wear in the pump pocket
• Check the gears, rotors, vanes and slides for
wear
• Remove any valves and check valves and bores
for wear
• Flat file pump mating surfaces
• Steel Plates
• Replace if they have hot spots
• Do NOT sand/resurface steel plates in any way
• Check clutch pack clearances
• Solenoids
• Check shift and ON/OFF lock-up solenoids
electrically, clean and reuse
• Pulsed solenoids, EPC and lock-up should
be replaced
• TORQUE ALL BOLTS EVERY TIME!
• Prepare accumulator bores using green Scotchbrite
• Flush the cooler with hot ATF until it’s clean
• Grind 1/16” off of torque converter bolts
• Allows for machining done to converter
during rebuild
• Add ground straps from bell housing to the frame
• Check line pressure during final road test
• Always do a final lift check — check for leaks, loose bolts, etc
Но соответственно, для совершенствования нужен опыт и наставник. Первого нет, второй отсутствует.